Portal: Underground

All concrete must be cured to ensure full and proper hydration of cementitious components control of shrinkage. Shotcrete is concrete placed pneumatically, therefore must be cured, as all concrete must be. The tunnel environment presents positive and negative conditions. The humidity in an underground space is generally high in humidity and constant in a moderate to cool temperature. Both conducive to slow egress of moisture from the concrete and “natural” curing. The negative in tunnel construction is ventilation air which is generally of high volume and high speed, which tends to dry the surface and “pull” important moisture out of the sprayed concrete. Most tunnels can tolerate extra water in the work space, therefore misting or spraying water onto the concrete surfaces, especially overhead, is the most practical method of curing. Sprayed on liquid membranes are effective as long as their interference with bonding of additional layers of concrete, sprayed or cast, is not an issue. Recommended reading: “Understanding and Controlling Shrinkage and Cracking in Shotcrete” by D.R. Morgan and C.Chan, published in the ASA Shotcrete magazine.

We often use shotcrete in lieu of cast in place concrete without using different design factors. Shotcrete is simply a method of placing concrete. Properly designed and constructed, the same reinforcing steel used for cast-in-place concrete or precast concrete should be able to be used with shotcrete constructed retaining walls. The only differences would be in the reinforcing detailing, in that the rebars should be tied in a configuration that makes them suitable for proper encapsulation with shotcrete. Avoid bundled bars or other conditions not conducive to proper shotcrete encapsulation. See “ACI 506R-90 Guide to Shotcrete” for guidance, except that it is possible to use much larger diameter bars than indicated in that document, as has been described in several articles. (See for example the article by James Warner on “Dealing with Reinforcing” in the Winter 2001 of Shotcrete magazine.)

The simplest way to clarify things is to advise your client that shotcrete is not a product but a process. Shotcreting is a process of installing concrete at a high velocity. Because the concrete is installed at a high velocity, it will have a higher density than conventional concrete in most cases. The increased density will provide reduced permeability and higher durability.

A shotcrete mixture can be designed and proportioned to meet virtually any job requirement. In this case, air entrainment must be specified. Whenever any concrete mixture (shotcrete mixtures included) will be exposed to freezing and thawing while critically saturated, air entrainment must be part of the mixture. The amount of air entrainment required depends on the maximum size of the coarse aggregate used. In general, for a mixture with a maximum-sized coarse aggregate of 3/8 in. (10 mm), the air content should be about 8% as-batched for a severe exposure condition.

Another key to longevity is reduction of permeability. As a mixture becomes denser, the transmission of fluids through the mixture becomes more difficult. This is especially critical when trying to protect reinforcing steel. When chloride ions and oxygen reach reinforcing steel, corrosion is initiated. Increasing the density by using products like silica fume, slag cement, and fly ash dramatically decreases permeability.

Discuss the curing and protection plan with the contractor prior to the start of shotcreting. Failure to cure and protect properly is the most common reason for poor concrete or shotcrete performance.

Another often overlooked element in obtaining an extended type of service life is maintenance of the concrete structure. By periodically cleaning the concrete and applying an appropriate surface sealer, materials that may lead to deterioration are removed from the surface and not allowed to penetrate the pore structure of the concrete.