PoolQ I had a concrete pool shell installed using gunite (dry shotcrete method) in July 2013. It was never finished due to unfortunate circumstances and has been exposed to the elements of weather over the last 2 years, mostly filled up with water from rain and, in the colder months, frozen like a pond. We would like to finish the pool but were told by the pool company that the concrete looked odd and we should have it strength tested. We had core samples taken from the walls and floor from a certified testing lab. The results from the six samples ranged from 1700 to 2200 psi (12 to15 MPa). When the pool was blown on July 3, 2013, it was to achieve 4000 psi (28 MPa) compressive strength in 28 days. Is it normal for the shotcrete strength to have weakened so much?
Properly produced concrete material shotcreted in place should gain strength over time, not lose strength. ASA recommends that concrete placed by the shotcrete method have a minimum compressive strength at 28 days of 4000 psi (28 MPa). Coring does damage the sample somewhat, so it is common to require core strength to meet 85% of the specified compressive strength. Cores should be no less than a nominal 3 in. (76 mm) in diameter for representative results because smaller cores (less than 3 in. [76 mm] diameter) are more subject to damage from the core extraction, affecting the reported strength. Thus, at 85% of 4000 psi (28 MPa) the minimum should be 3400 psi (23 MPa). Based on the reported values, and assuming a 3 in. (76 mm) diameter or greater core, the concrete strength is well below ASA’s recommended strength, and the strength you originally specified in 2013.